Overhaul of a steering gear HPU
Full recovery of the hydraulic power unit driving the rudder, with pump replacement and contamination brought back within specification.
Read the case studyTechnical portfolio
Completed projects, from diagnosis to a measured result
Each case documents the problem found, the engineering decision taken and the indicator that proves the result delivered.
Real cases
Filter by discipline
12 results
Transmission shaft manufactured by reverse engineering
Manufacture of a transmission shaft for discontinued equipment, worked up from the fractured component with no manufacturer drawing available.
Read the case study
Full overhaul of a mooring winch
Complete overhaul of a mooring winch with drum recovery, hydraulic drive overhaul and load testing.
Read the case studyRecovery of a cargo pump losing efficiency
Internal clearances recovered and wear rings manufactured, with the duty curve restored and proven on the test bench.
Read the case studyFlushing of high-pressure hydraulic lines
Contamination in a hydraulic system brought back within specification after repeated proportional valve failures.
Read the case studyRecovery of davit hydraulic cylinders
Overhaul of davit actuating cylinders with rod re-chroming and leak testing under load.
Read the case studyStructural reinforcement of a rotating equipment base
Diagnosis of excessive vibration and reinforcement of the base, with alignment and levelling corrected.
Read the case studyReplacement of a firefighting main
Replacement of corroded sections of the firefighting main, with workshop prefabrication and hydrostatic testing.
Read the case studyRetrofit of a steering system with an obsolete drive
Modernisation of the hydraulic steering drive, keeping the vessel's original structural interfaces.
Read the case studyIn-situ machining of a bearing housing
Dimensional recovery of a bearing housing without stripping the equipment, with a compensating bush manufactured to suit.
Read the case studyMaintenance of firefighting pumps
Complete maintenance of a firefighting pump set, with performance testing and a compliance dossier.
Read the case studyValve seat recovery by welding and machining
Recovery of an eroded seat by weld build-up in a compatible material and re-machining to the original dimension.
Read the case studyNo projects in this category Try another discipline, or talk to our team about your particular case.
How we document our work
Every project is recorded to the same structure
Standardised documentation is what makes it possible to compare interventions, build the equipment history and stand up to technical audits.
Objective
The problem that prompted the intervention and the operational constraint involved.
Scope
What was contracted, with a clear boundary between what is and is not included.
Execution
The sequence applied and the engineering decisions taken during the work.
Result
The measured indicator that proves the delivery — not a subjective assessment.
Technical support
Do you have equipment in a similar condition?
Most of these projects started with a description of a symptom and a shutdown window. Describe your situation and we will assess the engineering route.