Warranty on completed work and test follow-up alongside the client

Testing and Commissioning

No equipment leaves us without documented proof of performance.

About this service

What WF Service delivers in this discipline

Testing is the stage that turns work carried out into a result demonstrated. WF Service has its own test bench for hydraulic components and rotating assemblies, and also performs hydrostatic testing and commissioning on site.

Acceptance parameters are defined before the test, based on the manufacturer's specification, the applicable standard or the client's real operating conditions. The measured values are recorded and handed over with the equipment.

Commissioning on site closes the loop: the equipment is integrated into the system, adjusted under real operating conditions and handed to the client's team with technical guidance on operation and maintenance.

Scope of work

  • Bench testing of hydraulic cylinders, pumps and motors
  • Valve testing and cracking pressure adjustment
  • Performance testing of centrifugal pumps
  • Hydrostatic testing of lines, vessels and components
  • Leak-tightness and hold time verification
  • Hydraulic fluid contamination analysis
  • Commissioning and supervised start-up
  • Parameter adjustment under real operating conditions
  • Technical handover with report and guidance for the client team

What it means for your operation

What this service changes on your asset

Each point below is a practical consequence of how the work is carried out — not a generic promise of quality.

A proven result

Performance is measured and recorded, not estimated — the client receives data, not a promise.

Failures caught on the bench

Problems are found before reinstallation, avoiding a second shutdown of the equipment.

A baseline for predictive maintenance

The recorded parameters give a reference to compare against on future interventions.

Knowledge transfer

The technical handover briefs the client's team on operation and maintenance requirements.

Applications covered

Equipment and settings we work on

If your equipment is not on the list, it is most likely still covered — the list shows what we see most often, not the limit of what we can do.

  • Hydraulic cylinders and actuators
  • Hydraulic pumps and motors
  • Safety and control valves
  • Centrifugal pumps and motor-pump sets
  • Pressurised lines and vessels
  • Complete hydraulic systems
WF Service crew carrying out Testing and Commissioning
Warranty on completed work and test follow-up alongside the client Carried out by our own crews, with our own tooling

Related disciplines

Services that often form part of the same scope

Repair of hydraulic motors, pumps, manifold blocks and valves. We have a test bench for leak-tightness testing at 2500 bar

Hydraulic Maintenance

Maintenance, overhaul and commissioning of complete hydraulic systems, from single cylinders to power units.

View service

Manufacture and recovery of mechanical components using lathes, milling machines, grinders and welding

Mechanical Manufacturing

Built-to-design mechanical assemblies, from sizing through to delivery fully assembled and tested.

View service

Component recovery using oxy-fuel, TIG, MIG/MAG and stick (SMAW) welding.

Welding and Boilermaking

Qualified welding and heavy boilermaking for structures, vessels, tanks and component recovery.

View service

Technical support

Do you need testing and commissioning?

Tell us the equipment, the symptom observed and the window you have available. Our engineering team will come back with a preliminary assessment and a suggested scope of work.

Request a quote

Emergencies: 24/7 response on request